- How to set sup paddle height?
Place the paddle vertically on the ground and the bottom of it touches the toes. Put your hand to the top of the paddle and bend your elbow slightly. The height of the paddle is the right one for you.
- How to inflate the supboard?
Remove the valve cap and ensure the valve pin is in the “up” position. Then connect the pump hose to the valve and the inflatable pump. Watch the barometer while pumping. Before you are at 7 PSI, the pumping efficiency can be improved through the double action mode. After 7 PSI, you should switch to use the single action mode and observe the barometer, then stop pumping when the pressure of the sup board reaches the standard pressure.
- How to install the fin?
First you need to tell the orientation of the fins. The tip of the fin is towards the tail of the sup paddle. Then push the fin into the groove, and finally fix it with a clip.
- How to wear a leash?
Leash can improve the safety of paddleboarding. When wearing the leash, the leash cuff should wrap your ankle, and the other end is tied to the tail of the sup board.
- How To Carry Your Stand Up Paddle Board To The Water
There is a handle in the middle of the sup board. You can easily grab the board by the handle and walk to the water.
